Rise, Run, Tread, Nosing, and Width of a Stairway - Inspection Gallery - InterNACHI®

Rise, Run, Tread, Nosing, and Width of a Stairway: The tread depth should be at least 10 inches (254 mm). The tread depth is measured horizontally between the vertical planes of the foremost projection of adjacent treads and at a right angle to the tread’s leading edge. The greatest tread depth within any flight of stairs or stairway should not exceed the smallest by more than 3/8 inch (9.5 mm). The riser height is at most 7 and 3/4 inches (196 mm). The riser is measured vertically between leading edges of the adjacent treads. The greatest riser height within any flight of stairs or stairway shall not exceed the smallest by more than 3/8 inch (9.5 mm).

stairs Search Results - Inspection Gallery - InterNACHI®

Stair Treads and Risers - Inspection Gallery - InterNACHI®

Inspecting Stairways, Railings, and Guards at Commercial Buildings - CCPIA

Stairs - Risers and Treads - Building Codes and Compliance - ChiefTalk Forum

Chapter 5: Stairways

Interior > General - Inspection Gallery - InterNACHI®

4. Blogs by your San Antonio Home Inspector

Interior > General - Inspection Gallery - InterNACHI®

Stair tread depth? - Interior Inspections - InterNACHI®️ Forum

stairs Search Results - Inspection Gallery - InterNACHI®

ROPPE Light Duty Ribbed Design Brown 12-1/4 in. x 36 in. Rubber Round Nose Stair Tread 36812P110 - The Home Depot